Gima QUICK 240 Manual De Uso Y Mantenimiento página 9

ATTENTION !
Use only glassbeads to fill the container. Avoid any accidental contacts with fluids. Avoid
to use the sterilizer in an environment where the explosive gases may be present.
Place the sterilizer on a level surface so that air can freely circulate under the equipment
bottom side.
Keep the sterilizer at least 10cm. away from walls or others appliances to ensure an adequate
ventilation. Do not place the sterilizer near heat sources that could influence negatively
the thermostat.
Keep the door closed when the sterilization process is running.
Do not place any object on the upper part of the equipment.
Use adequate clamps for small tools to sterilize.
Do not clean, move or repair the sterilizer while it is connected to an electrical source and
when it is still hot.
ATTENTION !
When the sterilizer is operating do not put hands near it : glassbeads' temperature is
230°C.
The sterilizer must be used only for its designed purpose.
Improper use of the equipment is to the user's own risk and sole responsibility.
Thank you for having acquired our product.
This product meets the most stringent requirements regarding the selection of quality manufacturing
materials and also the final control. The product has a 12-month warranty, valid from the date it is
delivered by GIMA.
During the guarantee period free repair and/or replacement of any defective parts due to faulty
manufacture will be given, labour, postal, transport and packaging charges etc. are not included. The
guarantee therefore excludes components subject to wear and tear such as parts in rubber or PVC,
doppler probes, SpO
resistances, etc.
No compensation will be given for loss of use of the product.
Furthermore replacement or repairs effected during the guarantee period do not lengthen the duration
of the guarantee.
This guarantee is void in the event of: repairs effected by unauthorised persons or with
spare parts not approved by GIMA, damage or defects caused by negligence, blows,
abnormal use of the appliance or faulty installation.
The guarantee will be invalidated if the registration number has been removed, cancelled or altered.
Faulty appliances must be returned only to the retailer where the item was bought. Any item dispatched
directly to us will be refused.
CAUTIONS TO THE USER
MANUFACTURER'S RESPONSIBILITY
sensors, lamps, batteries, electrodes, handpieces, washers and packings,
2
GUARANTEE
9