Maintenance / Disposal; Technical Data - Intimus 34 CP7 Instrucciones De Uso

GB
and grasp the excess paper from the top and pull
it out.
4 . Clear any excess paper shreds from the feed ope-
ning. Be careful not to place your fingers near the
feed opening or serious harm could result.
5 . You are now ready to resume normal shredding.
5

Maintenance / Disposal

5 .1 Lubricating the cutting mechanism
Caution!
Danger of injury! Damage to the machi-
ne!
Do not use flammable synthetic oil, petro-
leum-based or aerosol products of any kind
on shredder.
Cross-cut cutting mechanisms should be oiled regular
after a certain operating time to maintain the cutting
performance.
This can be easily accomplished if you pour special
shredder oil (Order-No. see „Accessories", p. 10) as
shown on a sheet of paper and feed it through the in-
let guide to the cutting mechanism (Fig. 2).
Fig. 2 Lubricating the cutting mechanism
5 .2 Tip for energy saving
Always keep shredder off and unplugged when not in
use.
5 .3 Disposal of the machine
Always dispose of the machine at the end of its
service life in an environmentally responsible
way. Do not toss any part of the machine or its
packaging into the garbage.
10
Translation of the Original Operation Manual
Übersetzung der Originalbetriebsanleitung
6

Technical Data

intimus 34 CP7
Shred Type:
Shred Width:
Shredding Capacity:
Input:
Duty cycle:
Feed Opening:
Dimensions (WxDxH):
Noise level:
Weight:
7 Accessories
Designation
Oil bottle, 110 ml
NOTE!
When reordering accessories and to purchase
spare parts, please contact your intimus ser-
vice partner.
000181
Cross-Cut
1 x 5 mm
5 sheets (80g/m2)
220-240V, 50-60 Hz
30 min. ON / 30 min OFF
220 mm
410 x 320 x 600 mm
55 dB(A)
17,5 kg
Order-No .
94651 1 11/17
88035