Firmware Upgrade - Maxspect Jump Serie Manual De Usuario

Operating Instructions
7. Select then choose "Scan QR Code", the setting will be loaded
automatically.
EN
* You can also share the setting by sending the QR code to your friend. After the QR
code is generated, click"Share"then choose the platform you prefer to use. Your
friend saves the QR code in the album then scan it by choosing "Album" on step 7.

Firmware Upgrade

If there is new firmware available, it will be upgraded automatically in the first few
minutes after the account is logged in.
1. Open the APP and log in the account;
2. Choose the fixture you want to check the firmware version;
3. Click"∙∙∙"on the right upside of the APP;
4. Choose"Get device hardware info"to check the firmware version.
Name the Fixture
Only the account to which the fixture is bonded can name the fixture. Follow below
steps to name the fixture.
1. Open the APP and log in;
2. Choose the fixture you want to name;
3. Click"∙∙∙"on the right upside of the APP;
4. Choose"Set Device Alias"to name the fixture.
13