Safety Instructions; Working Area; User Manual - Perel Tools WTC180T Manual Del Usuario

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle
could harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste;
it should be taken to a specialized company for recycling. This device should be returned to your
distributor or to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Perel! Please read the manual thoroughly before bringing this device into service. If the
device was damaged in transit, do not install or use it and contact your dealer. Damage caused by disregard of
certain guidelines in this manual is not covered by the warranty and the dealer will not accept responsibility for
any ensuing defects or problems.
2.

Safety Instructions

There are potential hazards when using this cutter. It is therefore essential that anyone that
operates this machine reads, understands and applies following safety instructions.
Personal
Always wear ear protection when operating this machine.
Always wear safety goggles when operating this machine.
Always wear safety gloves when operating this machine.
Do not operate this machine when tired or under influence of drugs, alcohol or medication.
Caution! Loose clothing, jewellery or long hair can be caught in moving parts.
Check the condition of the machine before each use. Do not use when damage or
irregularities are noticed and contact a local dealer for service.
Repairs must only be carried out by qualified persons using original spare parts, otherwise
this may result in considerable danger to the user.
Electrical
Verify that the required input voltage is complaint with the mains outlet.
Do not modify power plugs. Mains outlet must be earthed.
Never use the power cord to carrying or pull the machine.
Only handle the power cord by the plug. Never pull out the plug by tugging the power cord.
Keep the power cord away from heat, oil, sharp edges and moving parts.
Keep the engine away from rain, moisture, splashing and dripping liquids.
Always disconnect mains power when device not in use or when maintenance activities are
performed.

Working area

Keep the tile cutter out of reach of children and unauthorized users at all times.
Do not use the machine in an explosive atmosphere or in the presence of flammable liquids,
gasses or dust.
Always use the machine in a clean and well lit working area.
V. 02 – 09/01/2013
WTC180T

USER MANUAL

3 ©Velleman nv