Standard Accessories - HIKOKI RB 40SA Instrucciones De Manejo

BLOWER SAFETY WARNINGS
1. Ensure that the power source to be utilized conforms
to the power requirements specifi ed on the product
nameplate.
2. Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the power
switch is in the ON position, the power tool will start
operating immediately, which could cause a serious
accident.
3. When the work area is removed from the power source,
use an extension cord of suffi cient thickness and rated
capacity. The extension cord should be kept as short as
practicable.
4. Use only the voltage shown on the nameplate to
supply power.
Using a voltage higher than shown will increase the
rotation speed abnormally and can cause injuries.
5. Do not put your hands or face near the blower
opening during use.
Doing so might lead to injuries.
6. Remove this unit a safe distance away from
electrical conductors when cleaning sections
carrying electrical power such as the electrical
panel.
7. Do not block the blower opening or intake.
Blocking the blower opening will cause an increase in the
motor rotation speed abnormally and might damage the
vanes on the inner section of the unit or cause injuries.
The motor might also overheat and cause a fi re.
8. Do not use in locations where infl ammable
materials such as lacquer, paint, benzene, thinner
or gasoline are present. Also do not let items such
as lighted cigarette butts be suctioned inside at
such locations.
Explosion or fi res might result.
9. Do not use in environments subject to heavy doses
of chemicals, etc.
Plastic sections such as the vanes on the inner section
of the unit might weaken and break, and injuries might
occur.
10. If you notice the unit is operating poorly or making
abnormal noises, immediately stop using and shut
off the power switch. Request an inspection and
repair from the dealer where you purchased the
unit or a HiKOKI Authorized Service Center.
Continuing to use while operating abnormally might
cause injuries.
11. If the unit is mistakenly dropped or strikes another
object, make a thorough check of the unit for
cracks, breakage or deformation, etc.
Injuries might occur if the unit has cracks, breakage or
deformation.
12. Do not use near objects generating high heat such
as stoves.
Fires might occur if used near such locations.
13. Make a thorough inspection if using the blower to
blow or clean viscous powder or dust particles.
Powder or dust particles might be suctioned in and
adhere internally, causing the vanes to break or injuries
to occur.
14. Do not leave on locations such as benches or fl oors
while still rotating.
Injuries might occur.
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
RB40SA / RB40VA : Blower
Read all safety warnings and all instructions.
Always wear eye protection.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2002/96/
EC on waste electrical and electronic equipment
and its implementation in accordance with
national law, electric tools that have reached
the end of their life must be collected separately
and returned to an environmentally compatible
recycling facility.
V
Rated voltage
Alternating current
n
No-Lode speed
0
min Revolution or reciprocations per minute
-1
Switching ON
Switching OFF
Warning
Disconnect mains plug from electrical outlet
Class II tool

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package
contains the accessories listed in the below.
○ Dust bag .......................................................................1
Standard accessories are subject to change without notice.
APPLICATIONS
○ Cleaning facilities and equipment in lumbermills,
cigarette-making plants, spinning mills, etc.
○ Cleaning devices and equipment in repair shops.
○ Blowing operation.
3
English