SALT CHLORINATOR
1. FOREWORD
READ, UNDERSTAND AND CAREFULLY FOLLOW ALL
OF THE INSTRUCTIONS IN THIS MANUAL BEFORE
INSTALLING AND USING THIS EQUIPMENT.
• In this manual, the pictograms opposite
indicate a WARNING, or a NOTE OF CAUTION,
accompanied by instructions to be followed
to the letter.
• Failure to comply with these instructions
may result in significant risk of damage to
the equipment and/or serious injury to people.
THESE INSTRUCTIONS MUST BE FOLLOWED
AND COMPLIED WITH.
2. SAFETY GUIDELINES
ELECTRICAL SHOCK HAZARD
To avoid the risk of injury or accident, install the
equipment out of reach of children and anyone
not authorised to operate and handle the
equipment.
Ensure that the equipment room in which the
equipment is installed complies with the standards
in force in the country of installation, at the time of
commissioning the equipment. If in doubt, contact
a qualified electrician. This equipment must also
be installed by an authorised, qualified person in
accordance with the electrical codes in force in the
country of installation at the time of installation.
The installation must also comply in all respects
with the technical specifications given in this manual
and in any document supplied with the appliance.
The equipment's electrical cables must be
protected against any accidental damage. A
damaged cable must be replaced immediately,
using only a cable identical to the original. Never
cut or extend the electrical cables.
Only authorised, qualified people may work on the
equipment in case of failure or to perform maint-
enance. Always disconnect the power supply before
carrying out any technical work on the equipment.
Do not modify the equipment. Any modification of
the equipment can lead to risks to people as well
as the environment, and result in the deterioration
of the equipment.
6
WWW.NORSUP.EU
ATTENTION
The detailed safety instructions in this manual are
not exhaustive. They detail the most common
risks encountered when installing and using this
equipment. Caution and common sense are
required when installing and using the equipment.
2. FUNCTIONS PERFORMED
Model
Chlorine
pH
Regulation of
product-
regulation
chlorine pro-
ion via
duction with
electrolysis
ORP probe
UNO
DUO
PRO
Alterations which serve the technological progress as well as errors excepted!
SALT CHLORINATOR
4. PACKING LIST WITH IN-LINE CELL Non-binding images
UNO model
Controller mounting
kit for electronics unit
(wall mount + screws
Electronics unit
+ plastic anchors)
In-line cell
1x
1x
1x
Accessories
holder
(equipped with
Power cable for
Power cable
2 reducers
electronics unit
for cell
and 5 caps)
1x
1x
1x
DUO model
This packing list also includes the items below.
Filter with
Injection
pH probe
ballast
connector
1x
1x
1x
PRO model
This packing list also includes the two sets of items below.
Saddle clamp
(in kit)
ORP probe
1x
1x
Measuring kit (optional):
Controller
mounting kit for
the measuring
chamber (screws +
Measuring
S
addle clamp
plastic anchors)
chamber
(in kit)
1x
2x
1x
Alterations which serve the technological progress as well as errors excepted!
Nut
Restrictor
Collar
2x
2x
2x
Salt/
Analysis kit
temperature
(test strips
/low-water
+ reference
Pool Ground (optional)
sensor
card)
1x
1x
1x
pH calibration
kit (pH 7
Probe
Semi-flexible
solution + pH
connector
Stopper
tubing
10 solution)
1x
1x
1x
Probe connector
ORP calibration solution
1x
1x
Semi-flexible
tubing
Valve
Fitting
Sealing tape
1x
2x
2x
ORIGINAL MANUAL NORSUP
EN
DE
FR
Seal
2x
ES
PT
IT
1x
1x
7