Descargar Imprimir esta página

Aiwa IC-M120 Instrucciones De Manejo página 2

Grabador en cirquito integrado

Publicidad

E
1
2
1
2
MODE / PAUSE
3
FILE
5
REC / STOP
4
REC
5
3
Select SP to record the sound more clearly.
About the V-SENSOR function, please refer to "V-SENSOR function"
below.
3 Press FILE repeatedly to select a recording file.
4 Orient the built-in microphone to the sound source.
5 Keep REC/STOP pressed for 1 second.
The REC indicator lights up in red, then recording starts.
a Recording track number
b Recording indicator
c Recording mode
d V-SENSOR indicator
e Elapsed recording time
Basic operation
To stop recording
Press REC/STOP or c/sPLAY/STOP.
To pause recording
Press MODE/PAUSE.
To resume, press MODE/PAUSE, REC/STOP or
c/sPLAY/STOP.
Note
You cannot change the recording file during recording.
To see the remaining recording time
Press FILE during recording or while in recording pause mode. The
remaining recording time is displayed while the button is pressed.
• The remaining recording time is approximate values.
When FULL is displayed
You cannot record any more. Erase unnecessary recordings.
V-SENSOR function
If you select V-LP
or V-SP
in step 2, the recording starts when the unit
k
k
detects sound above a preset level. If the unit does not detect the sound for
about 2 seconds, recording will pause and "SEnS" flashes.
This function prevents memory waste and empty recording.
Note
• The sensor level is factory-preset and you cannot change the level. Before
using the V-SENSOR function, please be sure to record once to confirm
the sensor level.
• When recording resumes after sound detection, the very first sounds may
not be recorded.
IC-M120(YU)ESF

Publicidad

loading