Kasanova DNA000001 Manual De Instrucciones página 7

AROMA DIFFUSER
1. Remove the upper part of the diffuser
2. Fill the tank with water up to the limit sing. The water temperature must
NOT be over 40°.
3. Add 2-3 drops of essential oil in the specific tray.
4. Replace carefully the upper part and make it correspond to the lower one.
Limit of water filling
water level detector: the device will switch off by itself when the water is used
up.
1. Remove the upper part of the diffuser
2. Fill the tank with water up to the limit sing. The water temperature must
NOT be over 40°.
3. Add 2-3 drops of essential oil in the specific tray.
4. Replace carefully the upper part and make it correspond to the lower one.
swinging disk
* the device will switch off by itself when the water is used up.
NOTE: for a right usage, the water in the diffuser must NOT exceed the
indicated limit.
POSSIBLE PROBLEMS
PROBLEM
The light does not switch
on and the diffuser does not
work.
The light switches on, the
diffuser works, but the
steam does not go out.
The light switches on but the
diffuser does not work.
The diffuser does not give
off enough steam.
POSSIBLE CAUSE
The cable might not be accu-
rately connected.
The water level might be too
low.
It might be too much water in
the tank.
The swinging disk might be
blocked up due to dirty water
or if water has left too long in
the tank.
SOLUTION
Ensure that the USB cable is
accurately connected to the
device and to the outlet.
Fill the tank until the indica-
ted limit.
Empty a bit the tank and
close it carefully.
Clean the tank and fill it
again with clean water.
7