Silver King SKSR Manual Tecnico página 2

Thank you for purchasing Silver King food service equipment. Our goal is to provide our customers with the most reliable equipment
in the industry today. Please read this manual and the accompanying warranty information before operating your new Silver King
unit. Be sure to complete and mail the warranty card within 10 days of purchase to validate your warranty.
INSPECT FOR DAMAGE AND UNCRATE
Upon delivery of your new Silver King unit, uncrate at once to inspect for possible damage following the instructions printed on the
exterior of the container. Report any damages to the carrier responsible for transportation and promptly present a claim for any
evidence of mishandling. Save all packaging materials if a claim is filed.
INSTALLATION
The stainless steel exterior of the cabinet has been protected by a plastic covering during manufacturing and shipping. This
covering can be readily stripped before installation. After removing this covering, wash the interior and exterior surfaces using a
warm, mild soapy water solution and a sponge or cloth, rinse with clean water and wipe dry.
Shelf
Inside the unit you will find a Shelf and a plastic bag containing Shelf Supports. The Shelf Supports with the "tang" go on the rear
Pilasters. This shelf system allows for easy adjustment to suit your needs.
Door Adjustment and Swing
Should the Door ever require straightening, loosen the Screws on the Hinges, square the Door with the cabinet and retighten the
Screws. Contact your Silver King dealer for information on switching your door swing from right hand hinges to left hand hinges.
Location
When locating your new refrigerator, convenience and accessibility are important considerations, but the following installation
guidelines must be followed;
Always avoid placing the refrigerator adjacent to an oven, heating element or hot air source that would affect the operation
•
of the unit.
For proper ventilation the unit requires the following minimum clearances:
•
3 inches on the sides, back and above the cabinet. Install the rear air baffle per the instructions included.
o
The unit must be level or tilted backwards slightly.
•
When placing the unit on a counter or shelf the structure must be able to support a minimum of 200 pounds.
•
The unit is designed to be sealed to the supporting structure surface with a waterproof sealant as required by NSF
•
International. To do so, locate the unit in its desired location (following the instructions), apply a bead of sealant around the
perimeter and smooth out with a finger to form a radius with the surface and the unit.
TECHNICAL MANUAL
SILVER KING MODEL SKSR REFRIGERATOR
1