Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
EN
A NEO 3
carton
contains two loudspeakers (black or white) and two plastic wall-mount
brackets.
(*) Power Taps (70V).................................
Power Taps (100V)....................................
Power handling (8Ω) ................................. 50W RMS (with overload protection)
Sensitivity (1W/1m) .................................. 87 dB
Max. SPL (1m) ............................................ 100 dB
Frequency Response ..............................
Elements.................................................... 2.5" Woofer
Dimensions ..............................................
Material (enclosure) ................................. ABS plastic
IP rating ..................................................... IP 54
RAL colour code ......................................
Material (grille) .........................................
Weight ....................................................... 0,5 Kg
(*) The power taps indicated on the selector switch are calculated for 100V line. In the case of 70V line installation, each power
tap will correspond to half the value.
Specifications are subject to change without notice
3
85
The connection type is selected through switch
(10W position for line, 8Ω for low impedance)
Make sure to select the correct power tap
position before connecting the loudspeaker
to a 70/100V line amplifier. If the low
impedance position (8Ω) is selected, the
loudspeaker could be damaged!
The connection is made through Euroblock terminals.
Ensure the correct polarity is observed.
5
W(980Ω)
10W(1kΩ)
150Hz - 20kHz
85 x 95 x 100 mm
RAL 9003 (W) / RAL 9004 (B)
Aluminium
User Manual/Manual de Uso
1
95
100
NEO Series
Publicidad
Manuales relacionados para Work Pro NEO 3
Resumen de contenidos para Work Pro NEO 3
- Página 1 A NEO 3 carton contains two loudspeakers (black or white) and two plastic wall-mount brackets. The connection type is selected through switch (10W position for line, 8Ω for low impedance) Make sure to select the correct power tap position before connecting the loudspeaker to a 70/100V line amplifier.
- Página 2 Wall-mount bracket Rear wall mounting part Threaded Ball Locking nut Fixation screw (x2) Use the wall mounting part (1) to mark the fixing points on the wall. Take into account the dimensions between holes and the diameters marked in figure 1. Drill wall and insert wall fixings.
- Página 3 Un set de NEO 3 contiene dos altavoces (color blanco o negro) y 2 soportes de pared de plástico. El tipo de conexión se selecciona mediante el conmutador( posición de 10W para line, 8Ω para baja impedancia) Asegúrese de seleccionar la correcta posición de potencia antes de conectar el altavoz a un amplificador de línea 70/100V.
- Página 4 Soporte de pared Pieza de fijación a la pared Rótula Tuerca de Bloqueo Tornillo de fijación (x2) Use la pieza de montaje a la pared (1) para marcar los puntos de fijación. Tenga en cuenta las dimensiones entre agujeros y los diámetros marcados en la figura 1.