Battery Installation; System Settings - Beper LOT 2013-120 Manual De Instrucciones

Tabla de contenido

Idiomas disponibles

Arm blood pressure monitor Use Instructions

Battery Installation

Slide battery cover off as indicated by arrow. Install 4 new AAA alkaline batteries according to polarity.

Close battery cover.

With power off, press "SET" button to activate System Settings. The Memory Group icon flashes.

1. Select Memory Group

While in the System Setting mode, you may accumulate test results into 2 different groups. This

allows multiple users to save individual test results (up to 60 memories per group.) Press " MODE "

button to choose a group setting. Test results will

automatically store in each selected group.

2. Time /Date Setting

Press "SET" button again to set the Time/Date mode. Set the month first by adjusting the " MODE

" button. Press "SET " button again to confirm current month. Continue setting the day, hour, and

minute in the same fashion. Every time the " SET " button is

pressed, it will lock in your selection and continue in succession (month, day, hour, minute.)

3. Saved Settings

While in any setting mode, press " ON/OFF " button to turn the unit off.

All information will be saved.

Note: If unit is left on and not in use for 3 minutes, it will automatically save all information and shut off.

Applying the Arm Cuff

1. Firmly insert air plug into opening located on left side of monitor unit.

2. With sticky nylon section facing outward, insert end of cuff underneath metal ring of cuff

3. Fasten cuff about 1-2cm (0.4-0.8'') above the elbow joint. For best results apply cuff to bare arm

and keep level with heart while testing.

Note: Do not insert air plug into opening located on right side of monitor unit.

This opening is designed for an optional power supply only.

Tabla de Contenido

Tabla de contenido