Power On/Off; Initial Setup; Basic Operation - DeWalt DCT418 Manual De Instrucciones

personal injury, ensure the screw (L) holding the belt hook is
secure.
IMPORTANT: When attaching or removing the belt hook, use only the
screw (L) that is provided.
The belt hook (M) can be attached to either side of the tool using only
the screw (L) provided, to accommodate left- or right-handed users. If
the hook is not desired at all, it can be removed from the tool.
To move the belt hook, remove the screw (L) that holds the belt hook
in place, then reassemble on the opposite side.
OPERATION
Installing and Removing the Battery Pack
(Fig. 4)
NOTE: Make sure your battery pack is fully charged.
FIG. 4
A
To install the battery pack (A) into the tool handle, align the battery
with the rails inside the tool's handle and slide it into the handle until
the battery pack is firmly seated in the tool and ensure that it does not
disengage.
To remove the battery pack from the tool, press the release button (N)
and firmly pull the battery pack out of the tool handle. Insert it into the
charger as described in the charger section of this manual.
Getting Started

POWER ON/OFF

1. To turn on the hand-held radar scanner, press the power on/off
2. To turn off the hand-held radar scanner, press the power on/off
The hand-held radar scanner will also power off automatically after
15 minutes of inactivity.

INITIAL SETUP

Press the power button (G) to turn on the hand-held radar scanner.
The first time the hand-held radar scanner is powered on, it will prompt
N
to select a language.
1. Press the right/down arrow button (J) or left/up arrow button (H) to
2. Press the OK button (I) to confirm selection.

BASIC OPERATION

The hand-held radar scanner identifies objects behind a wall surface
in two steps.
10
button (G) and hold for 0.5 seconds. Ensure that the unit is at least
6" away from the wall when powering on.
button (G) and hold for 2 seconds.
highlight English, Spanish or French.