Names Of The Parts; Before Use - Gardol GHSI 5045 Instrucciones De Manejo

Names of the parts

5
6
1 Safety blades
2 Protection shield
3 Wrap-around handle with ON/OFF
switch
4 Rear handle with ON/OFF switch
5 Power cord connecteur
6 Strain relief
7 Protective blade cover
8 Impact protector (only GHSI 5555)

Before use

Power connection
The machine can only be connected to a single-phase
a.c. current connection. The machine is protectively in-
sulated in accordance with classification II of VDE 0740.
Before using the machine ensure that the mains current
agrees with the operating voltage data on the machine's
identification plate.
Power Circuit Breaker
Machines which will be used in different outside
locations must be connected to a Power Circuit
Breaker.
Securing the power supply cable
Use only extension cords that are approved
for outdoor use and are not lighter than rubber-
sheathed cables of type H07 RN-F according to
DIN/VDE 0282 with a diameter of at least 1.5 sq.
mm. They cords must be splash-proof. If the con-
nection cable of this device should be damaged
it must be replaced by a workshop named by the
manufacturer only as this work requires the use
GB | Operating Instruction
4
3
2
7
of special tools.
• First connect the device plug with the connection line.
Form a narrow loop with the connecting cable, press
on the button and swivel the cable holder (X) out into
position A.
A
• Now insert the loop of cable from below into the mains
lead cleat. Once you have released the cable hook
button, it will automatically return to starting position
B and the cable will be held in place.
5
1
X
8