Publicidad
Idiomas disponibles
Idiomas disponibles
MC 4200
• The appliance is designed to process only small
quantities of food! Fill the container with the
maximum quantities specified in the table!
• Do not put hard foods such as ice cubes, nutmeg or
large pieces of chocolate into the container! The
blade can be damaged!
USING THE FOOD CHOPPER
Before using the appliance for the first time wash the transparent container, the protectivelid and the
blade in a sink.
WARNING: handle the blade with caution! DANGER OF INJURY!
1. Place the non slip mat (5) onto the work surface, rib side down.
2. Position the bowl onto the middle of the non slip mat(5)
3. Fit the knife blade over the pin in the bowl
4. Add your food, see processing guide. Cut large pieces of food into 1-2cm (1/2-3/4 in pieces). Don't
chop hard foods such as coffee beans, ice cubes, spices or chocolate – you'll damage the blade
5. Fit the cover (2). Make sure the slots in the cover (2) fit over the handles in the rim of bowl. The food
chopper will not operate unless the splashguard is fitted.
6.
Fit the power unit (1). The power unit will only fit correctly in two positions.
7. Plug in. Press down on the power unit for short lengths of time to produce a pulsing action – this
will avoid
over processing the ingredients. If the machine labours, remove some of the mixture
and continue processing in several batches, otherwise you'll strain the motor. Stop the machine and
scrape down if necessary. Do not run the food chopper continuously for longer than 10 seconds.
Leave to cool for 1 minute in-between each 10 second operation.
8. After use, unplug and dismantle.
CLEANING
Always switch off and unplug before cleaning. Power unit: Do not immerse in water. Clean it with a
damp sponge.Handle the cutting blade with care, they are extremely sharp.
Key
(1) Power Unit
(2) Cover
(3) Knife Blade
(4) Bowl
(5) Non Slip Mat
10
Publicidad
