Woosung Z PRO PIONEER Manual De Usuario página 4

DRAWING
ASSEMBLY INSTRUCTIONS / INFLATION / DEFLATION
Inflate your kayak with a pump from Z-pro or any pump designed for inflatable boats, and other low pressure inflatables. These types of
pump will have a hose and adapters to fit the valves on this kayak. Choose a smooth and clean surface to unfold your kayak. pump will have a hose and adapters to fit the valves on this kayak Choose a smooth and clean surface to unfold your kayak
1. Side tube valve(s) and bottom floor valve - please see drawing to the right:
Unscrew the valve cap(1). Screw the valve insert(2) onto its base(3) and check that
the valve cap stays accessible. Insert the pump hose end piece and inflate it until
you will reach the required pressure. After inflation tighten the valve cap
(clockwise). A slight air-leak before screwing the valve cap is normal. Only the
valve cap can ensure final AIR TIGHTNESS. To release air from the side tubes p
and bottom floor tube, unscrew the valve insert(2) from the valve base(3).
2. Please screw the valve insert(2) tightly again to prevent from air leaking.
3. Max. air pressure : the correct pressure for this item is :
0,07 bar / 1,00 psi(= 70 mBar ). Do not exceed it.
4. Inflation procedure and sequence : please see drawing to the right:
(1) Inflate the side tubes first. (1) Inflate the side tubes first
(2) And inflate the bottom floor tube last.
Any use of an air compressor may result in poor performance or damage to the kayak, and automatically voids all
warranties. If you leave your kayak exposed to the hot sun, check the pressure and deflate it slightly. Otherwise the
kayak may become over inflated and stretch the material. The ambient temperature affects the tube's internal
p pressure : a variation of 1°C/ 1.8°F causes a variation of the pressure in the tube of +/- 4 mBar (0.06psi) p
4
(1) Bow Cover
(2) Rope
(3) Inflatable Seat
( ) (4) Valve
(5) Stern Cover
(1) Valve Cap
(2) Valve Insert
(3) Valve Base
( p )