Bosch GFR 25 Manual Original página 14

OBJ_BUCH-2143-003.book Page 14 Friday, October 7, 2016 5:44 PM
14 | English

Switch off when transporting the ma-
chine to and from the area to be
worked on.
 Switch off and remove the battery
from the battery cartridge:
– whenever you leave the machine
unattended for any period,
– before clearing a blockage,
– before replacing the cutting head,
– before checking, cleaning or work-
ing on the machine,
– after striking a foreign object. In-
spect the machine for damage and
make repairs as necessary,
– if the machine starts to vibrate ab-
normally (check immediately).

Do not modify this product. Unau-
thorized modifications may impair
the safety of your product and may
result in increased noise and vibra-
tion.

Only use Bosch Professional Garden
Tool recommended and approved ac-
cessories.
 Beware that the tool may kick back
when a blade suddenly strikes a hard
object when cutting brush or scrub
vegetation. Take care to minimise the
effects of kick back.
 This tool is designed to be used with
the shoulder harness provided. Take
care to adjust the harness to balance
the tool correctly and reduce the po-
tential for operator fatigue in use.
 For Transport and Storage, Blade
should be protected using an appri-
ate cover.
F 016 L81 659 | (7.10.16)
Maintenance
For Your Safety

Warning: Switch off and remove
battery from machine before ad-
justing or cleaning.
 Use correct battery and charger.
 Always wear protective gloves
when handling or working near the
sharp blades.
 Please use the correct guards with
the correct cutting heads.
See figure 4 of illustrations.

To ensure long and reliable service,
carry out the following mainte-
nance regularly:
 Keep all nuts, bolts and screws tight
using tool kit provided to be sure that
the machine is in safe working condi-
tions.
 Examine the machine and replace
worn or damaged parts for safety.
 Ensure Bosch approved correct re-
placement parts are used.

Have the machine repaired only by an
authorized customer service agent.
Cleaning
 Before transport or storage ensure
machine is clean and free from de-
bris, if necessary clean with a soft,
dry brush.
 The following cleaning schedule
should be carried out after every 10
hours of work:
– Remove slip plate and thoroughly
clean area below.
– Open bump head spool and remove
any debris.
Bosch Power Tools