Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
After you connected the effect to the mains, the LED DMX scanner starts running,during the reset, the motors
are trimmed and the device is ready for use afterwards.
Stand alone operation
In the stand alone mode, the light can be used without controller. You can do without a controller as this
scanner features a built-in microphone, which provides automatic sound control.
Master/slave operation
Connect the master and slave-devices and adjust the settings as described above.
DMX-controlled operation
You can control the projectors individually via your DMX-controller, every DMX-controller has a different
occupation with different features.
Addressing
The Control board allows you to assign the DMX fixture address, which is defined as the first channel from
which the scanner will respond to the controller.
Please, be sure that you don't have any overlapping channels in order to control wach LED scanner correctly
and independently from any other fixture on the DMX data link.
If two, three or more LED scanner are addressed similarly, the will work similarly.
For address setting, press the Menu button until the display shows A.001 and set the desired address via the
up/down buttons.
Controlling:
After having addressed all LED scanner, you may now start operating these via your lighting controller.
Note: after switching on, the LED scanner will automatically detect whether DMX512 data is received or not. If
the data is received, the display will show "A.001" with actually set address. If there is no data received at the
DMX-input,. The display will show"A 001"
The situation can occur if:
1, the 3Pin XLR plug(cable with DMX signal from controller) is not connected with the input of the LED
scanner.
2, the controller is switched or defective, if the cable or connector is defective or the signal wires are swap in
the input controller.
DMX-Protocol
Channel 1-Horizontal movement (Pan)
Push slider up in order to move the mirror horizontally (Pan)
Gradual mirror adjustment from one end of the slider to the other (0-255,128-center)
The mirror can be stopped at any position you wish.
channel 2-Vertical movement (Tilt)
Push slider up in order to move the mirror vertically(TILT)
Gradual mirror adjustment from one end of the slider to the other (0-255,128-center)
The mirror can be stopped at any position you wish.
Publicidad
