Replacing The Drive Belt; Transportation And Storage - Greencut LJ400C Manual De Instrucciones

60

REPLACING THE DRIVE BELT

1. Disconnect the machine from the mains.
2. Using a Philips head screwdriver, remove the screw in the center of the strap cover.
3. Remove the cover.
4. Loosen the three tension screws inside the pulley box and then push the box down to loosen the belt
tension.
5. Remove the old drive belt.
6. Mount the new drive belt on the drive pulley first and then on the engine pulley.
7. Check the belt tension by squeezing the belt with your fingers. Push pulley housing up to increase belt
tension until there is approximately 6mm (1/4") of tension.
8. Tighten the tension screws securely.
9. Using a Phillips head screwdriver, reinstall the pulley cover and screw. Tighten firmly.

TRANSPORTATION AND STORAGE

• Allow equipment to cool completely before transporting or storing.
• Always store the product in a clean, safe, dry place with temperatures between 0º and 45ºC.
• The equipment is not weatherproof, and should not be stored in direct sunlight, high temperatures, or in humid
locations.
• Always store the machine with the cutting element guard installed.
• Store the machine out of the reach of children.
Pulley housing
Transmission
belt
Phillips screw
Motor pulley
Belt cover
Drive pulley
Tension screw