Star Pool AR1550 Manual De Instrucciones página 7

DO NOT TO MANIPULATE IN ANY CASE THE VALVE WITH THE PUMP RUNNING
The valve must be in FILTRATION position. The life of the filter gets longer with periods of
continued functioning not superior to 4h. Its daily needs of filtration are determined by the
volume in m3 of the swimming pool in relation with flow rate (m3/h), for 21ºC in water and
placed at 3'5m from the swimming pool. Stop at least 2h between every period of
functioning of 4h.
3
Volume m
=
hours
3
Flow rate m / h
Example:
3
42 m
=
' 7 63 h
3
5 5 ' m / h
2 cicles of 4 hours with an intermediate cicle of 2 horas to rest down the pump.
Cleaning
The solid particles contained by the swimming pool contains are gathered by the sink and
the skimmers, remain retained in the sand of the filter and in consequence the water flow
is constantly diminishing. When the pressure comes to 1'3kg/cm2, make a washing.
Proceed as follows:
Put the valve in WASHING positionand then pump will be start. Do it dunring 2 minutes.
Nevertheless, observe the window on the selector valve to verify that running time is
correct, since it depends on the dirt accumulated in the filter.
Rinsing
After a WASH of the filter and before putting the system in filtration, it is suitable to make a
RINSING to avoid that the first quantity of water, still turbid, goes directly to the swimming
pool. Just put the selector valve in RINSING position while pump is turner off. Turn on the
pump during 1 minute aproximately.
Nevertheless, to observe the window of the selector valve to verify that running time is
correct, since it depends on the dirt accumulated in the filter.
Recirculation
When selector valve is placed in this position, the water proceeding from the pump
circulates directly towards the swimming pool, without passing through the filter.
Draining
It is necessary to use a suction pump when the level is below the skimmer. When the
swimming pool has not an outlet in its the back, it is possible to empty it by the filter pump
by placing the valve in DRAINING position. To make this, open the valves of the sink and
close the ones of the skimmers and automatic cleaner.
Close
This position closes the water entry to the filter.
Wire replacement
In case of deterioration of the wire, proceed as follows:
• Disconnect the device.
• Slacken the screws that hold the lid of the box and open it.
Wash the sand before the first filtration
needed