Grex G9.1 Evolve Vivid N Com Seguridad E Instrucciones página 13

• VISOR MECHANISM SYSTEM
1 DISASSEMBLY
1.1 Open the visor completely.
1.2 By pressing the visor release button (A), slide the visor forwards until you hear aclick (Fig. 4).
1.3 Release the visor fastenings (B1 and B2) from their seat (Fig. 5).
1.4 Repeat the same steps on the other side of the helmet.
Important!: do not remove the visor's opening and closing mechanisms from the chinguard.
2 ASSEMBLY
2.1 Set the visor in open position by placing the visor fastenings (B1 and B2) into their seats in
the visor mechanism (Fig. 5).
2.2 Insert fastening B1 in the housing provided and press the visor against the shell in line with
fastening B2.
2.3 Slide the visor backwards until the visor locks into place.
2.4 Repeat the same steps on the other side of the helmet.
WARNING!!!
- Make sure that the system is working properly. Open the visor. By lifting the chinguard,
the visor closes automatically.
- Do not use the helmet if the visor has not been assembled properly.
- If the visor opening/closing mechanisms are not working properly or if such mecha-
nisms get damaged, please contact a GREX authorized dealer.
•
(Available as an optional accessory)
1 PINLOCK®INNER VISOR ASSEMBLY
1.1 Remove the visor.
1.2 Make sure that the inner surface of the visor is clean and check that the pin adjustment exter
nal levers are turned inwards.
1.3 Place the Pinlock® inner visor on the visor. WARNING: The silicone-sealed profile of the
Pinlock® inner visor should be in contact with the inner surface of the visor.
1.4 Insert one side of the Pinlock® inner visor on one of the visor pins and hold it in position (Fig. 6).
1.5 Widen the visor and fasten the other side of the Pinlock® inner visor to the second pin (Fig. 7).
1.6 Release the visor.
1.7 Remove the protective film from the Pinlock® inner visor and check that the entire silico-ne-
sealed profile of the inner visor adheres to the visor.
1.8 Fit the visor in the helmet.
CHECKING AND ADJUSTING THE INNER VISOR STRETCHING
Check the correct system assembly by opening and closing the visor. Check that both visors are
correctly fastened and do not move.
If the inner visor is not tightly fixed to the visor, move the external adjustment levers simultane-
ously upwards to increase the stretch (Fig. 8). This operation must be carried out gradually.
The maximum stretch is achieved when the pin adjustment external levers are turned outwards.
13