Midland BT1 INTERCOM Manual De Instrucciones página 33

Redial Last number (in stand by mode)
Conversation among passenger, driver
and the phone
Release the 'extended' conversation
above
GPS Navigator (only for driver's unit)
The control is done only by the GPS
INTERCOM
Start using the Intercom
Stop using the Intercom
BLUETOOTH MP3 player of the mobile phone (only driver's unit)
Activate the MP3 player/Play and Pause
Forword (next song)
Backword (previous song)
Deactivate the MP3 Player
WIRED CONNECTION
Activate /Deactivate
SETUP/PAIRING
Enter SETUP mode
Pairing a Phone or a GPS Navigator
Pairing the BT1 pillion's device
Reset all paired devices
SPECIAL SETUP CONFIGURATION
3 way conversation always on
Change VOX sensitivity or disable it
Exit SETUP mode
Long press of the Phone button
During a phone call, short pressure of the Intercom button on the unit which received
the call
Short pressure of the Intercom button
Start talking/short press the Intercom button
Stop talking (after 20 sec. you will return to stand by mode)/Short press the Intercom
button
Press and hold down the "Intercom" button for 3 seconds.
While the music play, short press of the Phone button
While the music play, short press of the AUX button
Press and hold down the "Intercom" button for 3 seconds.
Short press of the AUX button
Press the Intercom button for 7 seconds while the unit is off
While in Setup mode, press the phone button until the LED light flash Red and Blue
alternately
While in Setup mode, press the Volume + on one unit (the light will flash Red and
Blue alternately), press the Volume - on the other unit (the light will flash Red and
Blue alternately). On a successful pairing, both light turn to Blue for one second.
While in Setup mode, long press he Volume + and he Volume -. On a successful
reset, the Blue light will turn on for two second.
While in Setup mode, press the Phone and AUX buttons for 3 sec.
Steady Blue for two seconds= activated Double long flash = deactivated
While in Setup mode, press short the AUX buttons (blue light on). Now, press "Volu-
me +" or "Volume -"to increase or reduce sensitivity. Press again the AUX button to
confirm the new setting and go back to the SETUP mode (Red light always on).
Blue light flashing:
Once = VOX disable
Twice = very low sensitivity
3 times = low sensitivity
4 times = medium sensitivity.
5 times = high sensitivity
While in Setup mode, long press the Intercom button. The Red light will turn off and
the Blue light starts flashing.
15