Paoli Avvitatori DP 219 Manual De Instrucciones página 13

OPERATING AND MAINTENANCE MANUAL
HANDLING
L Clockwise rotation (tightening): Slide "T" to
the left the rotation reverse shaft and push
"P" the trigger (view figure Fig.3-A and
figure Fig.3-C).
ACCESSORIES ASSEMBLY
When changing accessory, always disconnect
the pressure lines.
Use only accessories suitable for the job.
L "Square drive without hole e with retainer
ring": Insert the accessory "A" in the square
drive of the tool, with an axial pressure
figure Fig.4-A).
MAINTENANCE
L At regular intervals supply it with the
addition of lubricant
order to keep the appliance efficient and to
extend its service life.
L Clean the supply filter and drain off the
condensation at regular intervals
figure Fig.1).
L Use only genuine spare parts and authorized
service organizations.
L Do not carry out maintenance with improper
tools, make use of the attached exploded
drawing with the list of spare parts.
L Indicate the parts most subject to wear,
to be dismantled and checked at regular
intervals, as well as a list of malfunctions, if
any, and the corrective action.
SCRAPPING
Separate the components on the basis of the nature of the materials of which they are made.
(view
(view figure Fig.1), in
(view
L Counter clockwise rotation (loosening):
Slide "T" to the right the rotation reverse
shaft and push "P" the trigger
Fig.3-B and figure
L "Square drive with hole and retainer ring":
Insert the accessory "A" in the square drive
of the tool, with an axial pressure, use
the pin "S" and the ring "R"
Fig.4-B).
L Every three weeks clean the motor by
introducing naphtha (~25cc) through the
air inlet, while keeping the trigger pressed;
then running the wheel gun clockwise and
anticlockwise. After the inside washing,
repeat the previous operation with oil for
air tools (~5cc). These operations must be
performed in a suitably equipped working
environment, complete with extraction
equipment for nebulised particles. Use
personal protective equipment.
L If the tool is left unused for long periods
we recommend putting some oil into the
air inlet and letting it run for a few seconds
before putting it away. In this way the
internal components will remain lubricated.
(view figure
Fig.3-C).
(view figure
ENGLISH
13