General Guidelines - Velleman HQ-Power VDPL110WL Manual Del Usuario

3.

General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
Keep this device away from dust and extreme heat. Make sure the ventilation openings
are clear at all times. For sufficient air circulation, leave at least 1" (±2.5 cm) in front of
the openings.
Protect this device from shocks and abuse. Avoid brute force when operating the device.

Familiarise yourself with the functions of the device before actually using it. Do not allow operation
by unqualified people. Any damage that may occur will most probably be due to unprofessional use
of the device.

All modifications of the device are forbidden for safety reasons. Damage caused by user modifications
to the device is not covered by the warranty.

Mechanical wear is not covered by warranty.

Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, lamp explosion, crash, etc. Using the device in an unauthorised way will void the
warranty.

Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and
the dealer will not accept responsibility for any ensuing defects or problems.

A qualified technician should install and service this device.

Do not switch the device on immediately after it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room temperature.

This device is designed for professional use on stage, in discos, theatres, etc. The VDPL110WL can
be used indoor (<35°C, <75%RH) with an alternating current of max. 240V AC/50Hz.

Lighting effects are not designed for permanent operation: regular operation breaks will prolong their
lives.

Use the original packaging if the device is to be transported.

Keep this manual for future reference.
4. Overview
Refer to the illustrations on page 2 of this manual.
1 DIP switch
2 DMX512 input
3 DMX512 output
5. Installation
Refer to the illustrations on page 2 of this manual.
5.1 Overhead mounting

Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable
norms.

The construction to which the device is attached should be able to support 10 times the weight of the
device for one hour without deformation.

The installation must always be secured with a secondary attachment e.g. a safety cable.

Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.

Install the device in a location with few passers-by and inaccessible to unauthorised persons.

Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in serious injuries.

For truss-mounting, use an appropriate clamp (not incl.) and fit an M10 bolt through the centre of
the (folded) bracket.

Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
V. 02 – 03/11/2017
VDPL110WL
4 power input + fuse
5 safety eye bolt
6 GND
4 ©Velleman nv