3.1.18 W
Arning
3.1.19 W
Arning
3.1.20 W
Arning
3.1.21 W
Arning
components, the high pressure jet is potentially dangerous. Do not use the
rotating nozzle kit, and always keep the jet at a distance of at least 30 cm during
cleaning.
3.1.22 W
Arning
specifically intended for the model in question is prohibited. All modifications to
the appliance are prohibited; any modifications shall render the Declaration of
Conformity null and void and relieve the manufacturer of all liability under civil
and criminal law.
3.2
SAFETY "MUSTS"
3.2.1 W
Arning
3.2.2 W
Arning
and comply with IEC 60364-1. Either a residual current device that will cut off
the power supply if the leakage current to earth exceeds 30 mA for 30 ms or a
ground fault interrupt device must be installed.
3.2.3 W
Arning
3.2.4 W
Arning
for the operator (30 mA).
3.2.5 W
Arning
3.2.6 W
Arning
cross-section.
3.2.7 W
Arning
3.2.8
W
Arning
clothing (PPE) and equipment needed to ensure the operator' s safety.
3.2.9 W
Arning
3.2.10 W
Arning
93899_.indb 21
. DO NOT move the appliance by pulling on the ELECTRIC CABLE.
. DO NOT allow vehicles to drive over the high pressure hose.
. DO NOT move the appliance by pulling on the high pressure hose.
. When directed towards tyres, tyre valves or other pressurised
. The use of non-original accessories and any other spare parts not
. All electrical conductors MUST BE PROTECTED against the water jet.
. The electric supply connection must be made by a qualified electrician
. DURING start-up, the appliance may cause network noise.
. Use of a residual current breaker (RCB) will provide additional protection
. Models supplied without plug must be installed by qualified staff.
. Use only approved electrical extension leads with suitable conductor
. Always turn off the switch when leaving the appliance unattended.
. High pressure may cause parts to rebound: wear all the protective
. Before doing work on the appliance, REMOVE the plug.
. Before pressing the trigger, GRIP the gun firmly to counteract the recoil.
English
21
16/9/8
9:48