Package Contents; Troubleshooting; Installation; Before Installation - Clarion CC720 Manual De Instrucciones Y De Instalación

Package contents

➀
➁
➂
➃
➄

4. TROUBLESHOOTING

The following symptoms are not malfunctions. Before having the unit serviced, check the
following points once more.
Symptom Reason
Wiring is incomplete or
No image
disconnected.
A fuse is burned out.
Poor image is
The lens cover is soiled.
produced
Sunlight or headlights from
vehicle in the rear are shining
directly in camera.
The environmnet is too dark.
No audio
Poor connection.
output
4
CC720
Camera with attached Mounting Bracket (A)
(universal mounting) and 7.0 m cable ................... 1
Mounting Bracket (B)
(for use with CAU001/CAU002) ............................ 1
Pan head screw M3 x 4 with washers
(for use with Bracket B) ......................................... 2
Pan head screw M3 x 16 with washers
(for use with Bracket B) ......................................... 2
Owner's and Installation manual ........................... 1
Solution
Check wirring once again and confirm correct
connections.
When using an independent power supply box,
check the fuse and, if burned out, replace with a
new one with theh same apacity (1A). If the fuse
burns out repaetedly, consult your dealer or
nearest Clarion Service Center.
Wipe lightly with a damp soft cloth. Do not rub
harshly with dry cloths since scratches may be
produced.
The image will return to normal when the light
striking the lens is removed.
The image display will be poor at night or dim. The
image will return to normal conditions of brighten
illumination.
Push the camera connector tighter
into the vehicle side connector.

5. INSTALLATION

Before installation

• Before installing the camera or its wiring,
read all safety warnings and be sure to
install the unit correctly.
• Before installing the camera permanently,
use adhesive tape to mount the camera
in its proposed position, then check the
image in the monitor to confirm proper
display before fixing the camera in its final
position.
• Make sure the head unit supports a
camera audio input, such as the Clarion
NX405, VX405 and NX706.
WARNING
• Disconnect the battery's negative (-)
terminal when installing wiring.
Precautions when using
double sided tape for installation
■ Do not install on glass or body
surfaces treated with fluorinated
resins or other water-repellent
treatments.
■ Do not install within the sweep of
a rear window wiper, or near the
window washer's nozzle.
■ Abide by the following rules in order
to prevent lowering of the installation
tape's adhesion.
• If possible, install on a day with clear
weather.
• Within the first 24 hours after
installation, do not expose the
installation to moisture (water, rain,
mist, snow, etc.), or subject the
installation to strong forces or impacts.
• When installation must be performed
under conditions of low ambient
temperature (20°C or below), use a
hair dryer to warm the surface of the
bracket where the double side tape is
to be applied.
• Do not touch the bracket-mounting
surface's double side tape, and do not
attempt to move or reset the tape after
initial application.
Notes:
• Before removing the protective
paper on the bracket, place it in the
proposed position on the vehicle
and confirm that the surfaces match
properly without gaps.
• When using screws to install the
bracket, use the right-left screw holes
provided on bracket A.
CC720
5