Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION AND USE GUIDE
1. Check the physical integrity of the regulator. The regulator must not be
damaged or broken in any way. It is recommended not to use the equipment in
case of physical damage to the regulator.
2. Make sure the input voltage of the regulator matches the voltage of the outlet.
Voltage outside the specified range will cause damage to the regulator and
equipment connected to it.
3. Install the regulator in a cool, dry environment away from fire, moisture,
excessive dust, and other hostile environments.
4. Make sure that the ventilation holes are always clean for proper cooling to
prevent overheating of the equipment.
5. The temperature of the regulator will be increased whenever it operates with
current fluctuations, without this representing a risk to the equipment.
6. In case of overload the regulator will shut down. Remove the overload and
switch it on again.
7. In case of excessive heat, physical damage, unusual noises or any other
technical failure, disconnect the equipment and contact your dealer for
authorized technical support.
Model
Nominal Voltage
Capacity
Input voltage range
Input frecuency range
Output voltage
Output frecuency
Surge protection
Outlets
Symptoms
Possible Cause
Regulator switch is
off
Regulator
The electrical outlet
does not turn
is out of power
on
Regulator is
overloaded
www.satpcs.com.co
Technical Specifications
SAT RGU1208
120Vac
1200VA/600W
95VAC ~ 145VAC
43 Hz ~ 67 Hz
120Vac +/-10
Same as the input
80 Joules (Energy 10/100us)
8 x Nema 5-15R (4 AVR / 4 Surge)
Troubleshootings
Way to solve
Locate the regulator power switch and
turn it on.
Try connecting the regulator to
another outlet.
Disconnect some devices to decrease
the load and turn the switch back on.
Publicidad
