Before First Use; Using Your Hand Mixer; Tips - Bella BASICS Manual De Instrucciones

Before First Use

Wash the Beaters in warm, soapy water, rinse, and let dry.
Product may vary slightly from illustration.
Eject button
Motor
housing
Slots for beaters

Using Your Hand Mixer

WARNING: Do not plug the Power Cord into an electrical outlet until the Beaters have been securely
attached.
1. Attach the Beaters: Locate the two half circles near
the end of each Beater. Also locate the breaks in
the Slots in the Motor Housing. Insert the Beaters
into the Slots such that the half circles go into
the breaks. Push down until the Beaters click into
place.
2. Slide the Speed Switch all the way down so "OFF"
is visible. This is the off position. Plug the Power
Cord into a standard 120-volt AC electrical outlet.
3. Place the Beaters into the ingredients to be mixed.
4. Slide the Speed Switch to the desired setting.
Speeds range from "1" (lowest) to "5" (highest).
CAUTION: To prevent the Mixer from overheating,
do not operate it for more than five minutes at a
time. Allow four minutes off after five minutes of
operation.
NOTE: For best results, begin with the lowest speed setting ("1") and increase to a higher speed as
necessary.
5. When adding ingredients, turn the Mixer off and allow the motor to stop. Lift the Beaters out of the
mixture and rest the Mixer on its Heel. Add ingredients and place the Beaters back into the mixture
before continuing.
6. When mixing is complete, turn the Mixer off. Make sure the motor has stopped before lifting the
Beaters out of the mixture. Unplug the Power Cord from the electrical outlet.
WARNING: Always turn the Mixer off and unplug the Power Cord before leaving the Mixer
unattended and when it is not in use.
7. Eject the Beaters by firmly pressing the Eject Button.
CAUTION: Never eject the Beaters while the Mixer is operating.

Tips:

• Refrigerated ingredients such as butter and eggs should be at room temperature before mixing
begins. Set these ingredients out ahead of time.
• Assemble all ingredients and utensils near the Mixer.
• To eliminate the possibility of eggshells in your recipe, break eggs into a separate container first,
then add them to the mixture.
• When mixing egg whites, be sure the mixing bowl and beaters are thoroughly clean and dry. Even a
small amount of oil on the beaters or in the bowl could cause the egg whites to not aerate.
Speed switch
Heel
4
Beaters
Two half circles
Align with
breaks in slots in
motor housing