Screen Icons - Husky 935 263 Manual De Instrucciones

Pre-Operation (continued)
6. MR Button – Displays the records in the memory. The records are recalled from the latest to the earliest.
7. LCD Display – Once you turn on the tool, the first display is the temperature (in Fahrenheit). After about two
seconds, it will automatically display the absolute angle in degrees.
8. Encased Vertical Vial and Horizontal Vial
9. Laser Pulling Head – The laser is emitted from the aperture at the end of the laser pulling head. Always avoid
exposure to laser radiation when using the digital level laser.
10. Hanging Hole – Hang the tool here for storage purposes.
11. Battery Compartment – Holds two AAA batteries.
12. Working Base – For accurate measurement, always protect the base from damage or distortion.
13. Magnets – Three magnets for securing the level to steel surfaces.
14. Rubber Grip

SCREEN ICONS

M1 (M1...M9)
Operation
CHANGING THE DISPLAY UNITS
1. Press the ° %/In/Ft button to convert the measurement units
between degrees (°), pitch (in/ft), and slope (%). Figure 3 shows
an example of the LCD display showing a degree measurement.
Up/Down Indicator – Zero Line (0°) always indicates the level position.
The bias and the right arrow indicate up or down, away from the level (0°).
Battery Capacity Icon – Indicates the power remaining in the batteries. Replace
batteries if the black power bar has disappeared.
Beeper Icon – When the beeper function is active, this icon will appear on the screen.
Memory Icon – Indicates the order of the angle being saved in the memory.
Figure 3