Taurus VAC 3000 Manual De Instrucciones página 10

- Do not use the appliance if it is tipped up and do
not turn it over.
- Disconnect the appliance from the mains when
not in use and before undertaking any cleaning
task.
- Store this appliance out of reach of children and/or
persons with physical, sensory or reduced mental
or lack of experience and knowledge.
- Use the appliance and its accessories and tools
in accordance with these instructions, taking
into account the working conditions and the
work to be performed. Use the appliance for
operations different from those intended could
result in a hazardous situation.
SERVICE:
- Any misuse or failure to follow the instruc-
tions for use renders the guarantee and the
manufacturer's liability null and void.
DESCRIPTION
A Side buttons for opening the cover
B Vacuum chamber
C Sealing band
D Sealing band
E Foam bands
F Vacuum valve
G Sealing function button LED
H Vacuum and sealing function button LED
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all products' packaging has
been removed.
USE:
- Unroll the cable completely before plugging it in.
- Connect the appliance to the mains.
- The buttons Will light up.
HOW TO PRODUCE THE VACUUM USING A
PACKAGING BAG:
- Place the food to be packed inside the bag. Do
not fill the bag to the limit; always leave a space
of at least 5 cm.
- Open the cover of the vacuum packing machine
by pressing the two side buttons.
- Insert the top part of the bag into the vacuum
chamber. To obtain good sealing, the bag must
be free of creases.
- Make sure that the air intakes of the vacuum
chamber are not covered by the bag.
- To get a good seal the bag should not have
wrinkles, dust or waves. Make sure that the
area where the seal is going to be made in the
bag is completely dry.
- Close the cover by pressing the two ends of the
appliance downwards until the packing machine
is firmly closed.
- Press the LED button for vacuum and sealing
function. The appliance will start the vacuum
function and the green LED will light up.
- Then the sealing function will start, the red LED
will light up.
- Keep the hands pressing the lid for a better
seal.
- At the end of the process the LED will turn off.
- To open the lid without any difficulty, slightly
stretch the valve and press the buttons to remo-
ve the bag.
- Note 1: You can cancel the process by pressing
the button again.
HOW TO PROCEDURE THE VACUUM USING
THE PACKAGING ROLLS:
- Cut to desired size.
- Make the seal at one of the ends to obtain the
packing bag.
- Open the cover of the vacuum packing machine
by pressing the two side buttons.
- Insert the top part of the bag into the vacuum
chamber. To obtain good sealing, the bag must
be free of creases.
- Close the cover by pressing the two ends of the
appliance downwards until the packing machine
is firmly closed.
- Press the LED button for sealing function. The
appliance will start the sealing function and the
red LED will light up.
- At the end of the process the LED will turn off.
- Keep the hands pressing the lid for a better seal.
- To vacuum pack, follow the instructions above.
TIP FOR MAKING A BETTER VACUUM:
- Do not fill the bag to the limit; always leave a
space of at least 5 cm.
- To obtain a good seal, the top of the bag must
be clean and free of creases.
- Do not wet the open end of the bag.
- Do not leave too much air in the bag. Press on