Camera Use: Photos - Juguetronica MICRO HEXADRONE VCAM HD Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ABSOLUTE CONTROL FLIGHT MODE
When you are flying in absolute control enabled mode, the
micro hexadrone moves according to your position and not
in relation to the direction that it is pointing its front (image 1).
With this activated flight mode, both the movements and the control of the drone are simple and
intuitive.
Activation absolute control flight.
After the synchronization, be sure that the control front is ahead in micro hexadrone (image 2).
When you press the button "absolute control", it will sound three beeps and the LED indicators of
micro hexadrone flash. The "absolute control" is enabled.
To turn it off, again press the "absolute control" button. Then a beep will sound and the LED stops
flashing. The "absolute control" is disabled.
PRECAUTIONS:
After disabling the absolute control, micro hexadrone should fly properly. Otherwise, it
performs an automatic adjustment.
To do this, place the micro hexadrone on a flat, horizontal surface. Then move both levers to
the lower left corner (see picture) for 2-3 seconds. The drone of the LED indicators start flashing
quickly. After 2-3 seconds, the drone of the LED indicators turn
the lights steadily.
The adjustment was done correctly.
FUNCTION RETURN HOME
When the micro hexadrone straying too far from your position simply by pressing a button, you
can make it return to the starting point.
Operation.
Pay attention to the antenna of the control if it is directed to the rear of the micro hexadrone.
Press the button "return home automatic" and a beep will sound confirming the order. The micro
hexadrone return flying to your position automatically. If any movement occur in the direction
lever, the function will be turned off again and you will have control of the steering.
IMPORTANT: The "return home" function is the one that the drone come
back to the place that took off. Therefore, it returns only for you if you are
in the same position in which position you were when you started flying
micro hexadrone.

CAMERA USE: PHOTOS

Before you start flying, be sure that the microSD card is properly installed in the entry, you will find
it on the right side of micro hexadrone (image 1).
To take a picture while you are flying with micro hexadrone, touches
the button "Image / Video Capture" once, without keeping your finger
on the button. You will see that the blue LED blinks also once, indicating
that the picture was taken.
1
Absolute control Button
2
Front
Rear
1
11

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido