Installation; Before Installation; Precautions When Using Double Sided Tape For Installation - Clarion CC720 Manual De Instrucciones Y De Instalación

5. INSTALLATION

Before installation

• Before installing the camera or its wiring,
read all safety warnings and be sure to
install the unit correctly.
• Before installing the camera permanently,
use adhesive tape to mount the camera
in its proposed position, then check the
image in the monitor to confirm proper
display before fixing the camera in its final
position.
• Make sure the head unit supports a
camera audio input, such as the Clarion
NX405, VX405 and NX706.
WARNING
• Disconnect the battery's negative (-)
terminal when installing wiring.
Precautions when using
double sided tape for installation
■ Do not install on glass or body
surfaces treated with fluorinated
resins or other water-repellent
treatments.
■ Do not install within the sweep of
a rear window wiper, or near the
window washer's nozzle.
■ Abide by the following rules in order
to prevent lowering of the installation
tape's adhesion.
• If possible, install on a day with clear
weather.
• Within the first 24 hours after
installation, do not expose the
installation to moisture (water, rain,
mist, snow, etc.), or subject the
installation to strong forces or impacts.
• When installation must be performed
under conditions of low ambient
temperature (20°C or below), use a
hair dryer to warm the surface of the
bracket where the double side tape is
to be applied.
• Do not touch the bracket-mounting
surface's double side tape, and do not
attempt to move or reset the tape after
initial application.
Notes:
• Before removing the protective
paper on the bracket, place it in the
proposed position on the vehicle
and confirm that the surfaces match
properly without gaps.
• When using screws to install the
bracket, use the right-left screw holes
provided on bracket A.
5
CC720