Emptying The Appliance; Thermal Cut-Out Reset - Caterlite J709 Manual De Instrucciones

UK
Operation
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
plastic coatings are thoroughly removed from
all surfaces.
Note: Before using for the
first time, clean the interior of
the appliance and all parts in
warm soapy water, then rinse
thoroughly.
2. Ensure the Temperature Control knob is set to
"MIN".
3. Remove the lid and fill the appliance to at least
half of its capacity.
4. Replace the lid. Twist to lock.
5. Connect to the mains power supply and turn
the power switch On (I). The Power Indicator
light illuminates.
6. Set the Temperature Control knob to the
required temperature. The Heat Indicator
illuminates and the appliance heats the water.
Thermal Cut-out reset switch
Temperature Control knob
4
J709_J722_ML_A5_v5_20190628.indb 4
Lid
Urn
Level indicator
Tap
On/Off switch
WARM Indicator
HEATING Indicator
WARNING: Reduce the set
temperature if the water begins
to boil. DO NOT allow the water
to boil constantly.
7. When the water has reached the set
temperature the 'Warm' light illuminates and
the water is ready to be dispensed.
Note: Once the water
temperature drops 5-10ºC then
the appliance will reheat the
water.
Serving
1. Place a suitable vessel beneath the tap.
2. Pull the tap towards you to begin dispensing.
3. Raise the tap handle to close the tap.

Emptying the Appliance

Drain the appliance by using the tap to empty.

Thermal Cut-Out Reset

This appliance is fitted with a Thermal Cut-Out
safety feature. Should the temperature exceed safe
levels the appliance will automatically cut power.
The Safety Cut-out switch is located on the
underside of the appliance. To reset the appliance:
1. Empty the appliance and allow to cool.
2. Press the reset button until it clicks.
WARNING: Ensure the appliance
has cooled down and is empty
before resetting the switch, as
it may need to be tipped slightly
to gain access to the switch.
3. The appliance is now reset and can be used as
normal.
2019/6/28 17:36