LaserLiner RangeXtender RX 30 Manual De Instrucciones página 6

2 Working with the laser receiver RX
Use the laser receiver RX for levelling over longer distances
or when the laser lines are no longer visible. Switch on with
button F; control lamp G will light up.
Line lasers:
RX 30:
Set the line laser to hand receiver mode. The laser lines will
now pulsate with high frequency, making the laser lines darker.
The laser receiver can detect these pulsating laser lines up to
a maximum distance of 30 m. Minimum distance from the
laser device about 3 m.
Now move the receiver field (B) of the laser receiver through
the laser lines upwards and downwards (horizontal laser line)
and/or sideways (vertical laser line) until the centre LED lights
up. Now mark the horizontal and/or vertical reference dimension.
Minimum distance from the laser device about 3 m.
!
Pay attention that the laser lines are not reflected by
reflective surfaces. Such reflections can lead to false
indications.
Rapid peeping
(lower LED)
The light intensity of the laser lines is greatest at
!
the centre and diminishes toward the ends. This
can reduce the maximum reception range of the
laser receiver.
06
EN
This button switches hand receiver
mode on and off.
This button is used to establish the
tolerance range.
30 mm
Laser
Continuous tone
(middle LED)
= mark the
reference
slow peeping
(upper LED)