Nordcap CR 90 Serie Manual De Instrucciones página 5

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 54
INSTALLATION
Remove the appliance from the packaging. Make sure that all protective plastic film and coatings are thoroughly removed from
all surfaces. To prevent injury or damage to the unit, we recommend that the appliance should be unpacked and set up by two
people.
Maintain a distance of 20cm (7 inches) between the appliance and walls or other objects for ventilation. Increase this distance if
GB
the obstacle is a heat source.
The appliance should be placed on a solid level floor to reduce noise and vibration. Level the appliance by adjusting the screw feet.
The temperature in the place where the SALADETTE is located must be between 10°C and 32°C (Climatic Class 4). Avoid locatin g
it indirect sunlight or near heat source such as an oven or a radiator.
Please make sure the appliance is properly ventilated.
Check that the power supply and voltage used comply with the details on the rating plate. The plug must be accessible after
installation.
Correctly connect and disconnect the plug. When inserting ensure the plug is fully engaged. When unplugging do so so by
holding the body of the plug. Never pull the supply cord directly.
If the SALADETTE is to be shut down for long period, switch it off and disconnect the plug from socket outlet. Clean the appliance
and leave the door&lid open to prevent odor.
Important! For your personal safety, this appliance must be properly grounded (earthed). This appliance is equipped with
a cord having a grounding wire with a grounding plug. The plug must be inserted into an outlet that is properly grounded and
installed. Consult a qualified electrician or service center if you do not completely understand the grounding instructions. If doubt
exits as to whether the appliance is properly grounded, have a qualified electrician check the circuit to make sure the outlet is
properly grounded.
If the cable does not reach the nearest socket, either rearrange your store layout or ask a qualified electrician to fix a ne w socket.
If power is cut off, wait for at least 3 minutes before restarting the appliance to avoid damaging the compressor.
Do not place any appliance such as microwave oven, toaster, etc, which give off heat on the appliance.
Fit the shelves/drawers
Note: If the unit has not been stored or moved in an upright position, let it stand upright for approximately 12 hours before operation.
Note: Before using the appliance for the first time, clean the shelves and interior with soapy water.
Note: This is vital for ensuring correct drainage of condensation.
• Place one pair of guides on either side of the cabinet at the desired height.
• Slide the shelf/drawer into place.
• Repeat for the remaining shelves.
5

Publicidad

Tabla de contenido
loading

Tabla de contenido