Lorell LLR00201 Manual Del Usuario página 5

FILTER REPLACE INDICATOR
The POWER light flickering continuously indicates that it is time to replace the filter. Replace the filter according to the directions
then press the POWER/UV-C button and hold for 5 seconds to restart the system. The light will stop flickering.
*Combination Filter will last approximately 6 months.
1. Open the front cover from the top.
2. Remove the combination filter by pull the two strips.
3. Insert new Combination Filter into the unit. Consult the strips on the filter for correct installation direction.
4. Reattach the extra Pre-filter to the Combination Filter.
5. Reattach the front cover of the unit and securely latch into place.
6. Press and hold POWER/UV-C Button for 5 seconds to reset Filter Change Indicator.
The air purifier should be cleaned at least once every month and the outer Pre-/Activated Carbon Filter attached to the HEPA
Filter should be cleaned every month. More frequent cleaning may be required depending on environmental conditions.
FILTERS
Clean with the brush attachment of your vacuum cleaner. This will remove lint and dirt.
Front (Pre-filter& Carbon filter)
NOTE:
-
Only the Extra Pre-filter is washable And make sure the pre-filter is dry when fix back the pre-filter to the combination filter.
-
The Combination Filter is one filter system. The multiple layers include: the Pre-filter, Activated Carbon Filter and HEPA
Filter.
INSTALLING & REMOVING FILTERS
CLEANING & MAINTAINING
THE COMBINATION FILTER
Back (HEPA filter)
5