Replacing Parts; Technical Data - tomado TWC3701W Instrucciones De Uso

The rubber of the squeegee has a limited life span and we recommend replacing it when it is damaged. The rubber and other
components are available via Tomado.
Slide the old rubber out of the slot and carefully slide the new rubber into the slot of the squeegee. Do not use too much force
and do not pull the rubber.
If placing the new rubber poses problems, you can loosen the screws at the back of the squeegee attachment. Remove
the cover and place the rubber in the slot. Place back the cover and fasten it again with the screws.
The appliance cannot be switched on
See what the indicator led indicates:
 The indicator led does not light up or flashes slowly: Charge the battery.
 The indicator led flashes quickly after overload. The appliance no longer works. Contact your supplier or our customer
service
Streaks are left behind when cleaning
 Clean the rubber.
 Turn around the rubber by removing it and placing it back the other way around. Wet it with water or soap to make this
process easier.
 If necessary, replace the rubber when both sides are worn.
 Adapt the dosing of the cleaning agent.
There is water leaking from the ventilation openings
 Empty the collection reservoir (max. 150 ml collection capacity).
Protection factor
Capacity collection reservoir
Maximum battery usage time
Voltage battery
Connected load
Charging time

REPLACING PARTS

TROUBLESHOOTING

TECHNICAL DATA

IPX4 Outlet voltage, charger
150 ml Outlet current, charger
30 minutes Weight
3.7 V Work width
20 watts Type of battery
3 hours
EN - 18
5 V
800 mA
700 grammes
280 mm
Lithium