Cleaning And Maintenance - Mx Onda MX-EG2750 Manual De Usuario

Stove off
Close the regulator key and turn the control button to the on position. If the
flame does not go out, remove the regulator from the cylinder, the flame will go
out when there is no more gas left in the gas hose.
If the stove is not going to be used for a long period of time, remove the
regulator from the bottle and replace the protective cap of the bottle.

CLEANING AND MAINTENANCE

Cleaning and storage
Before cleaning the stove, make sure it is completely cold. Do not use alcohol
or abrasive products and do not allow the device to come into contact with
volatile agents such as gasoline, solvents, insecticides, etc.
1. Disconnect the cylinder regulator and remove the cylinder from its housing.
2. Clean the outer surface as well as the bottle compartment with a slightly
damp cloth with a soapy solution.
3. To clean the burners, remove the protection grid and wipe the surface clean
and dry.
To store the stove, disconnect the regulator from the bottle, then remove the
bottle and store it in a well ventilated area, away from combustible materials
and heat sources, never in a basement or attic. Protect the stove from dust with
a plastic or a cover.
Maintenance
Each time the stove is to be put into operation, it is necessary to check the gas
hose and replace it if it is worn, damaged or expired. For replacement, contact
an authorized installer.
We recommend that a technician check the stove every 2 years.
8