Comunello RS Manual De Instrucciones página 13

4. INSTALLATION
CAUTION: the rain sensor begins to operate normally approximately one minute after it has been connected to
the electricity network. This period of time enables the sensor to reach the required temperature.
FOR THE INSTALLER – IMPORTANT
- The New Rain gauge must be permanently connected to the power supply network and is not equipped
with any type of 230 Vac electric line sectioning device. The installer is responsible for installing a sectio-
ning device in the system. An omnipolar switch with overheating category III must be installed. It must be
positioned in such a way that it is protected against accidental closures.
- For connections (power supply and outlet contact) we recommend the use of flexible wires with an insula-
ting sheath in harmonised polychloroprene (H05RN-F). The wires should have a minimum cross-section
of 0.75 mm .
2
- Fasten the connection cables using the cable clamp supplied with the product kit.
- Handle the sensor with care during the assembly process and make sure that all components are properly
assembled. Pay particular attention to the ceramic plate and the flat connection cable. When closing the
box again, it must fold back on itself normally.
- It is very important to establish an exact location so that the product is exposed to rain.
- Fix the device to the wall using the screws and rawlplugs supplied with the product, in the correct position
(see figures 1-2, page 6).
- Make sure that the sensor remains tilted at approximately 45 degrees (Fixing area at the top, round end of
the box at the bottom).
- Do not paint or varnish the sensitive surface of the sensor.
- The dirt which accumulates on the surface of the sensor restricts its sensitivity: we therefore recommend
that it is cleaned once or twice a year using a damp cloth, after the electricity supply has been disconnected.
- All operations requiring the opening of the casing (such as installation, programming and repair, etc.)
must be carried out by skilled professionals only.
- Rain sensor
FOR THE USER - IMPORTANT
- The device should not be used by children or by individuals with reduced physical or psychological abili-
ties unless supervision is provided or instruction given on how to operate it.
- Do not let children play with the device; keep radio controls out of their reach.
- CAUTION: Keep this instruction manual in a safe place and adhere to the important safety instructions con-
tained within it. Non-adherence to these instructions may lead to property damage and serious accidents.
- Examine the system frequently to check for any signs of damage. Do not use the device if it needs to be repaired.
- If the connection wires have to be replaced, please contact a qualified technician only.
4