toolport 3,66 m Serie Manual De Instrucciones página 33

3,66 m series
GB
Instruc! ons
Select a fl at surface for the tent. Unpack the boxes and check if all listed parts are included.
with a cloth. In colder weather condi" ons we suggest to bring the roof to room temperature
before installing.
Make sure that the wing nuts are always facing the inside when assembling.
1
Take a triangular arch (4) and connect this with the side arch (3).
Now Connect the arches with the roof struts (5), by using 45 mm screws (12) and the wing nuts (15).
2
Repeat step 1 for the next elements and place these as shown in the instruc" ons in a row on the ground.
3
Now connect the arches through the side struts (7) and (8) with each other.
Make sure that in the front segment only the struts (8) are used.
4
Begin fi rst assembling one side. Connect the side arch (3) with legs (1) and (2). Fix the frame with the diago-
nal strut (6). Fasten the diagonal strut (6) with the legs using the 75 mm screw (14) and the wing nut (15).
Secure the frame to the ground with the ground clamp (17) and ground nails (20).
5
Unfold the tarpaulin (22) and pull this over the frame. Pay a$ en" on especially to the edges and corners of
the frame to avoid damaging the tarpaulin.
6
Guide the cross strut (9) into the ring in the lower end of the roof and fasten this with the fasteners (16).
Tighten the roof cover (22) at the corner foot (10) with the ratchet (21).
7
Fasten the rear wall (24) with the help of the elas" c rings (19) to the frame. It is be$ er to anchor the lower
ends of the tarpaulin with sand in order to secure it.
Wikinger Carport
33