Inserting / Replacing Batteries - OWIM Z31833 Instrucciones De Montaje

If necessary, clean the battery and
device contacts before inserting the
battery!
Promptly remove dead batteries from
the product!
Inserting / replacing
Q
batteries (fig. C / D)
P ush the cover
O pen the battery compartment cover
by loosing the screw with a cross-
8
head screwdriver.
I f necessary remove the old batteries.
Insert new batteries! Make sure you
put the batteries in the right way
round. This is shown in the battery
compartment
C lose the battery compartment cover
again by tightening the screw.
The signal LED
approximately every 2 seconds and
simulates the operation of the fake
camera.
T hen push the cover back over the
camera casing
backwards.
7
.
10
flashes red
5
.
1
GB/MT 43