Robopac ROBOT S6 Instrucciones De Uso página 68

Robot autopropulsado para envolver con películas plásticas extensibles
Tabla de contenido

Publicidad

Capítulo 10
ANEXO 1
The innovative characteristics of the CBHD1 range of battery chargers are the following:
1.
Advanced technology
2.
Charging process fully controlled by microprocessor.
3.
Universal input voltage: 100-240 Vac
4.
Charging process start in the "soft start" mode.
5.
Automatic reset upon connection of a new battery and automatic start of a new charging cycle.
6.
Protection against polarity inversions, short-circuits, over-voltages or anomalies by means of
an output relay.
7.
Battery to battery charger connection without sparks on the output terminals with obvious
advantages for the active safety, thanks to the recognition of the battery voltage downstream the
normally open output relay.
8.
Signaling of possible anomalies by red LED fl ashing or by yellow LED fl ashing.
9.
Insensitive charge parameters in case of
10.
Effi ciency > 85%.
11.
Output ripple at maximum charge lower than 100mV.
12.
Start of the charge cycle even with 2V batteries.
On switching on a new battery charger of the CBHD1 series, the charger will check the battery
voltage and decide whether to start the charging process. If the battery is not connected to the battery
charger, the red LED will fl ash. If the result of the test is positive after 1 second the charging of the
battery can start, with the red LED on. The output relay closes and the current of the fi rst phase rises
slowly till the nominal value programmed is reached.
If the user disconnects the battery from the battery charger during the charging process, after a few
seconds the battery charger will re-initialize and prepare to start a new charging process.
The progress of the charging process is shown by three LED's: red, yellow and green, as in the whole
range of the battery chargers.
The green LED shows the end of the charging or the last phase in case of deep charging process; in the
former case, the relay is opened to disconnect galvanically the battery from the battery charger.
Please fi nd in the following table a list of the visual signals of the CBHD1 series.
SIGNAL (LED)
Red LED on
Yellow LED on
Green LED on
Yellow LED fl ashing
Red LED fl ashing
Green LED with 2 fl ashings
Red LED with 2 fl ashings
Español
ELECTRONIC BATTERY CHARGER
OPERATING MANUAL
TECHNICAL FEATURES OF THE CBHD1 SERIES
High frequency system.
±10% network voltage oscillations.
OPERATING PRINCIPLE OF THE CBHD1
VISUAL SIGNALS
First phase of charge in progress
Second phase of charge in progress
End of charge or maintenance phase
ANOMALIES
UNSUITABLE BATTERY OR BATTERY NOT CONNECTED OR OUTPUT SHORT
CIRCUIT
SAFETY TIMER EXCEEDED
INTERNAL SHORT CIRCUIT
INITIAL TEST
Battery charger confi gured for recharging Gel or AGM batteries
Battery charger confi gured for recharging Lead-acid (Wet) traction batteries
MEANING
- 60 -
2

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido