Operational Instructions - Global 988934 Manual Del Usuario

Installation
Required tools for assembly two 17mm wrenches
Part identification #11 fork assembly, #12 handrail
#13 cylinder assembly, #14 Chassis assembly, #15
Handrail guide and #16 connecting bolts; 4 sets.
1. On an even surface, place the fork assembly #11 on
the chassis #14 as in the drawing.
2. Insert the handrail #12 through fork assembly #11
and Handrail guide # 15; until it meets with the
chassis #14., aligning the bottom hole of cylinder
pump with the chassis #14.
3. Remove the lower nut on both sides of the chain
assembly, being careful not to let the chain slip
through. Connect the upper portion of the chain to
the handrail #12 and then the lower portion to the
chassis #14. Tighten the bolts and using the cotter
pins supplied to secure.
4. The forklift height can be adjusted after installation
via the chain bolt.
5. Connect the handrail #12 and Chassis #14 using the
connecting bolts #16 supplied.
6. Make sure all parts are connected properly and
bolts are tight.
7. Make sure operation is steady without and with a
rated load.
Hydraulic Principle
Drawing
Best Value Lift Stacker
Attention & Warning
1. Use lift stacker on flat, hard surfaces.
2. Do not exceed maximum load capacity. Transport

Operational Instructions

1. Lock wheel brakes and confirm height release valve
2. Footstep pole adjusts fork pump height. To lower
3. When the load exceeds 1.2 times of the load capacity
4. During transport, forks must be in the lowest
5. Descending speed may be adjusted by modifying
6. WARNING! When raising fork, do not pump
7. WARNING! When handling heavy loads, turn release
8. WARNING! When rising operation ceases, verify
Daily Maintenance & Inspection
1. Inspect forklift prior to use. Do not operate if
2. Inspect hydraulic system for oil leakage.
3. Perform monthly inspection of forks, wheels, chains,
4. Perform recommended lifting cylinder maintenance.
Please fill in the specified hydraulic oil at the following
temperatures listed below:
When replacing oil, adjust pillar piston pole to
lowest position.
3
goods according to load curve ensuring
load balance.
is closed.
forks, turn height release valve slowly until reaching
desired height.
the safety will lock so that the forks cannot rise. This is
to ensure safe operation.
position for safety.
the positioning ring angle on the release valve pole.
footstep pole too quickly as this may cause cylinder
to deplete.
valve slowly for stability.
release valve is securely closed for fork stability.
damaged or in poor condition. Inspect all moving
parts for issue or noise.
and more.
Replace hydraulic oil at 20 hours of run time and once
every 18 months or 300 hours whichever comes first.
Temperature
23°F~ 113°F
(equivalent to ISOVG68)
5°F~ -41°F
(equivalent to ISOVG46)
1 Out-pushing Cylinder
2 Turning Lifting and Falling Valve
3 Safety Valve
4 Oil Returning Valve
5 Work Valve
6 Work Cylinder
User's Manual
Hydraulic Oil
L-HM68 hydraulic oil
L-HM46 hydraulic oil