Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
CHECKING UNIT CHARGE
When the master power switch is turned on, look at the power indicator LEDs. No lit LEDs
indicates that your unit must be recharged before use.
UNIT CHARGE LEVEL BASED ON LED INDICATORS:
•
No LEDs illuminate: unit battery drained - recharge immediately!
•
1 LED: 20% charge
•
2 LEDs: 40% charge
•
3 LEDs: 70% charge
•
4 LEDs: 100% charge
JUMP STARTER OPERATING INSTRUCTIONS
IMPORTANT: Read these instructions carefully before each use of the jump starter
functionality. Ignoring these instructions could lead to physical or mental injury,
bodily harm, or even death as well as damage to vehicles or other objects.
•
Press the unit charge indicator button; at least 3 LEDs should illuminate before
attempting to jump start a vehicle.
•
Connect the RED clamp to the vehicles positive (+) battery terminal.
•
Connect the BLACK clamp to the vehicles negative (-) battery terminal.
•
Firmly insert the blue end of the jumper cable into the jump start socket of the
battery unit.
•
Turn the vehicle ignition switch and start the vehicle. Leave the vehicle running to
continue charging the battery.
•
When the vehicle is started, disconnect the blue end of the jumper cable from the
battery unit.
•
Disconnect the red and black clamps from the vehicle battery terminals.
CHARGING OTHER DEVICES
After connecting auxiliary power cables, press the indicator light switch if charging
doesn't begin.
USB-POWERED DEVICES
Plug a USB cable or use the provided adaptor cable to the USB 5V 2A output port.
Note: certain tablets, large phones, and other devices may not be able to draw sufficient
power from the USB port to charge while in use. See your device manual for minimum
charging specifications.
–3–
Publicidad
Tabla de contenido
