Kreg PRS1015 Manual Del Propietário página 11

Use a scrap piece of wood to test the setup. If you feed the scrap past
the bit and it runs into the leading end of the outfeed fence face, the
fence is too far forward and you're not removing enough material. Use
the micro-adjuster to move the fence back.
If the bit gouges the scrap at the trailing edge, the fence is too far back,
and you're removing too much material. Use the micro-adjuster to move
the fence forward.
Featherboards
The T-slot on the front face of the fence accepts Kreg True-
FLEX Featherboards, PRS3010 (single pack) or PRS3020
(twin pack).
Using Your Router Table Fence
Optional Kreg Router-Table Accessories
Move fence back
Workpiece
hits outfeed
fence face
Move fence forward
Workpiece stop
The T-slot on the top edge of the fence accepts the Kreg
PRS7850 Precision Router Table Stop that pivots out of the
way when not in use.