Technical Data - Martin Yale Papermonster TG10 Instrucciones De Uso

GB
REPLACE THE CUTTING MAT
Figure 7
- Move the cutter head to one end of the guide
rail.
- Take out the cutting mat with one finger from
the groove far from the cutter head.
- Insert the new cutting mat to original posi-
tion.
MALFUNCTION
DISPOSING OF THE MACHINE:
Dispose of the machine in an envi-
ronmentally sound fashion at the
end of its usefull service life. Do not
dispose of any of the parts included
in the machine or its packing with
household trash.
Description
XXXXX
Note: For orders of special accessoires and spare parts, please contact your dealer.
Cutting capacity:
Cutting length:
Dimensions (L*W*H):
Weight:
SPECIAL ACCESSOIRES

TECHNICAL DATA

guillotine: 5 sheets
straight: 3 sheets
skip: 3 sheets
wave: 3 sheets
guillotine: 320 mm
rotary: 320 mm
450 x 195 x 50 mm
1.1 kg
TRIMMER
Note
A spare cutting mat is stored in the
guide rail. When you need to change
cutting mat, take it out as shown in
Fig 8.
Figure 8
Order-No.
7 7
REPLACE THE CUTTER HEAD
When the cutting blade is damaged or the edge is
not sharp, you need to change the cutter head.
- Pull out the end cap from the base
(see Fig 9A)
- Draw out the guide rail from the base
(see Fig 9B)
- Move out the cutter head on the other side of
the guide rail (see Fig 9C)
- Replace the cutter head with a new one, fix
the guide rail on the base, place the end cap
in the original position.
Figure 9
xxxxx
TG10