Loading The Tool; Tool Operation - ABAC G-301 Manual De Uso Y Mantenimiento

EN

4. LOADING THE TOOL

4.1 Connect the air tube (1).
4.2 Lower the magazine
Pull the magazine cover back (2).
4.3 Insert a bar of fasteners into the magazine.
Make sure that the points of the fasteners are
loaded downwards. Also make sure that the
fasteners are not dirty or damaged (3).
4.4 Push the magazine cover forward until it
locks into place (4).

5. TOOL OPERATION

5.1 You are advised to lubricate the tool before
each use (see section 6) (1).
5.2 Empty the magazine.
Connecting the air using the quick coupling (2).
5.3 Adjust the operating pressure so that it
remains within the operating pressure range
specified for the tool (3).
Load the fastening elements inside the
magazine according to the instructions in
paragraph 4.
5.4 Check that the fasteners penetrate correctly
by shooting nails into a wooden sample. If
the fasteners do not reach the desired depth,
adjust the air pressure to a higher value so as
to achieve the desired result. If the model is
equipped with a depth adjustment device, turn
the thumb wheel to obtain the desired depth
(4).
WARNINGS: do not exceed a value of 8 bar
(0.8 Mpa)
catch.
26
1
2
3
4
OIL
1
2
3
4
8 bar
max
6
6
b
6
P
f
i
a
a
W
m
l
t
d
7
7
D
M
f
F
D
P
I
r
P
i