MRA KTM Duke 125 Instrucciones De Montaje página 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA windscreen
1 Holder, pair
4 Elastic nuts M5
4 Plastic washers 12x5x0.5mm
4 Lens head screws, M5x20mm
2 Hexagonal cheese-head screw M6x35
2 Screens 12x6x1mm
2 Distance sleeves M6 20mm
4 Distance sleeves 3mm
4 O-rings 4,5x1,5
Fitting the screen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Remove the two socket screws on the front covering (P1). Ensure that the covering
does not fall off.
3. Install the holding plates provided onto the motorcycle with the plastic washers, the
socket screws, the well nuts and the 20mm distance sleeves (P2 + 3).
4. Align the holding plates on the motorcycle (P3). Do not tighten the screws fully yet.
5. Place the M5x20mm lens head screws provided with the plastic washers through the
MRA screen and place the 3mm distance sleeves against these from behind. Secure
these with the O-rings supplied.
6. Mount the MRA windscreen to the motorcycle and tighten the lens head screws.
7. Now you can fully tighten the M6x35mm socket screws on the holding plates.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
KTM Duke 125/390 2017-
Article No..
--- Allen key 3, 4, 5mm
11360
10629
10635
10673
11358
10559
11181
10872
10992
3
Required tools