BH Tecnovita YR50 Instrucciones De Uso página 9

Temperature range: -10 / 40 ºC
Humidity: 30-85% RH
OPERATING INSTRUCTIONS
1. Before use, it is recommended to charge the device with the enclosed USB cable.
2. Peel off the orange plastic film from one side of the enclosed electrode gel pad and install the electrode
pad onto the back side of the control unit as shown in the picture.
3. Place the device onto the treatment areas, press down firmly and ensure a full and firm contact with skin.
4. Press the On/Off button to turn on the unit, indicated by the LED light and buzz sound for 1 second.
5. When turned on, the device works at combination mode.
6. Press the "+" button to increase the pulse intensity, and press the "-" button to decrease it. Each time
the intensity level is changed by pressing "+" or "-", the light will flash once and also the sound will buzz
once.
7. Press the "+" button for 3 seconds to select a desired pulse mode according to the following order:
1,2,3,4,5. Similarly, pressing the "-" button for 3 seconds the selection will be done downward. (5,4,3,2,1).
PLEASE NOTE: The Mode 1 is a combination of the others 4 modes. Each time the mode is changes, light
and buzz sound will activate twice.
8. The countdown timer is 20 min. When time is over, the unit will turn off automatically. The unit could be
also turned off anytime by pressing the On/Off button, indicated by a triple light flashing and a triple
buzz sound.
Note: The device will automatically power off when not in use on any treatment area, indicating a light and
a sound on for 3 seconds and then flashing and buzzing 3 times.
RECOMMENDED PRACTICE
• Treat each part of the body for a maximum period of 20 minutes.
• Start from the lowest intensity and gradually adjust to a comfortable level on a scale level from 1 to 15
making sure of a constant comfortable filling.
• Be sure that the area to be treated is free of perspiration, dirt, creams and oils and that the skin is
healthy and free from abrasions.
• In order to extend their lifespan, keep electrode gel pads in the storage holder immediately after use.
• The electrode gel pads are disposable and should be replaced when they lose their adhesiveness.
9