Types Of Work - Hilti TE 50 Manual De Uso

5.1.2 Fitting the depth gauge (optional)
1. Release the side handle clamping band by turning the handle grip.
2. Slide the depth gauge from the front into the 2 guide holes provided.
3. Tighten the side handle clamping band by turning the handle grip.
➥ The depth gauge is fitted. To set the drilling depth:
4. Release the screw at the depth gauge.
5. Adjust the depth gauge to the desired drilling depth.
6. Tighten the screw at the depth gauge.
5.1.3 Fitting/removing the accessory tool
CAUTION
Risk of injury! The accessory tool gets hot during use.
▶ Wear protective gloves when changing the accessory tool.
▶ Do not place the hot accessory tool on readily flammable materials.
1. Apply a little grease to the connection end of the accessory tool.
2. Push the accessory tool into the chuck as far as it will go (until it engages).
➥ The product is ready for use.
3. Pull the chuck back as far as it will go and remove the accessory tool.
Use only the recommended grease supplied by Hilti. Use of unsuit-
able grease may cause damage to the product.

5.2 Types of work

ATTENTION
Risk of damage by incorrect handling!
▶ Do not operate the switches for direction of rotation and/or function
selection during operation.
Observe the safety instructions and warnings in this documentation and on
the product.
5.2.1 Drilling with hammering action (hammer drilling)
1. Set the function selector switch to the "Hammer drilling" position
2. Press the drill bit against the work surface.
3. Press the control switch.
➥ The product starts.
5.3 Chisel positioning
CAUTION
Risk of injury! Loss of control over the chisel direction.
▶ Do not operate the tool when the selector switch is set to "Chisel
positioning". Turn the function selector switch until it engages in the
"Chiseling" position.
*2102963*
Printed: 14.12.2018 | Doc-Nr: PUB / 5283567 / 000 / 03
7
2102963
4
5
6
.
English 9