Carrying out a measurement
4.5.
Please mount corresponding adapter (see Chap. 4.3) before you switch on the
device. Check the position of the setting sleeve (see Chap. 4.4). This must have
engaged before every measurement.
Switch on the device by pressing the On key. After that, an information screen with
the serial number appears briefly. Now the device changes into measuring mode.
You can begin the measurement.
Insert the device with adapter into the spindle shaft
centrally and straight.
Activate the workpiece clamping, where you
introduce the entry force.
The currently acting entry force is displayed, as
well as the maximum entry force indicated below
that.
By repeated pressing of the On key, the device switches off again. The same result
occurs with the AUTO-OFF function if the device is not used for 3 min.
Heinrich-Röhm-Str. 50, 89567 Sontheim/Brenz., GERMANY, Tel. (49)7325/16-0
Operation
Spindle
shaft
Meas. Unit with
adapter (here
19